NetComm Wireless NF18ACV User Manual page 91

IPSec Settings
To create a new IPsec connection, click the Add New Connection button on the IPSec Tunnel Mode Connections page. The IPSec Settings page will be displayed.
VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
UG01040 v 1.04 December 2018
I T E M
IPSec Connection Name Enter a meaningful name to identify the IPSec tunnel.
Tunnel Mode Select the applicable IPSec tunnel mode.
Remote IPSec Gateway Enter the IP Address of the IPSec server to connect to.
Tunnel access from Local Select which remote addresses local IPSec connections are able to access .
IP Address from VPN Enter the IP Address to be used locally for the IPSec tunnel.
Subnet mask for VPN Enter the subnet mask to be used locally for the IPSec tunnel.
Tunnel Access from Remote Select which local addresses remote IPSec connections are able to access.
IP Address for VPN Enter the IP Address to be used on the remote end for the IPSec tunnel.
Subnet mask for VPN Enter the subnet mask to be used on the remote end for the IPSec tunnel.
Key Exchange Method Select the type of IPSec exchange is to be used on the IPSec tunnel.
Authentication Method Select the applicable authentication for the IPSec tunnel.
Pre-Shared Key Enter the pre-shared key (if applicable) to grant access to the IPSec tunnel.
Perfect Forward Secrecy Select to use Perfect Forward Secrecy during key exchange for the IPSec tunnel.
Advanced IKE Settings Configure advanced IKE settings for the IPSec tunnel such as the encryption method or key life time.
Apply/Save button Click to save and activate the new connection.
The new rule will then be displayed in the IPSec Tunnel Mode Connections table.
D E F I N I T I O N
© NetComm Wireless 2018
91 of 93