Management - Snmp Agent - NetComm Wireless NF18ACV User Manual

Management – SNMP Agent
The Simple Network Management Protocol (SNMP) allows a network administrator to monitor
a network by retrieving settings on remote network devices.
To do this, the administrator typically runs an SNMP management station program such as
MIB browser on a local host to obtain information from the SNMP agent, in this case the
NF18ACV (if SNMP is enabled).
VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
UG01040 v 1.04 December 2018
An SNMP 'community' performs the function of authenticating SNMP traffic.
A 'community name' acts as a password that is typically shared among SNMP agents and managers.
I T E M
SNMP Agent
Select
Read Community Enter a read type or accept the default: public
Set Community Enter a community type or accept the default: private
System Name Enter a recognisable system name or accept the default:
NF18ACV
System Location Enter a system location or accept the default: unknown
System Contact Enter a system location or accept the default: unknown
Trap Manager IP Enter the IP address of the trap manager.
Save/Apply button Click to save your settings and start the SNMP service.
D E F I N I T I O N
Enable to start this service.
© NetComm Wireless 2018
60 of 93