NetComm Wireless NF18ACV User Manual page 76

Extra Advanced Wireless Settings for 5 GHz only
Regardless of the 802.11n/EWC setting (it can be Auto or Disabled), the 5GHz channel has six additional settings.
VDSL/ADSL2+ Dual Band AC1600 Gigabit Gateway with VoIP – NF18ACV
UG01040 v 1.04 December 2018
I T E M
Regulatory Mode Select: Disabled, 802.11h or 802.11d
The default is Disabled.
Pre-Network Radar Checks to avoid channels that contain radar systems.
check
Available only in the 802.11h Regulatory Mode, see last setting.
The default is: -1
Enter the number of seconds to check for radar on a channel before establishing a network.
Used for 802.11h only.
In-Network Radar check Checks to avoid channels that contain radar systems.
Enter the number of seconds to check for radar when switching to a new channel after a network
has been established. Used for 802.11h only.
TPC Migration (db) Enter the Transmitter Power Control (TPC) mitigation setting in decibels (db) as : 0(off), 2, 3 or 4
The default is 0(off)
Iperf Support Select Enable if you want the NF18ACV to run the IPerf server application used by your ISP to
measure network speeds. Only enable if instructed to do so by your ISP.
Default setting: Disable
Video Error Correction Settings include: RX Auto Enable Decode, RX Disable Decode, TX Enable Sequencer, TX Enable
Sequencer (IPTV Mode), TX Enable Encode, TX Enable Encode (IPTV Mode)
D E F I N I T I O N
© NetComm Wireless 2018
76 of 93