Fluke 4322 Operator's Manual page 144

4322
Operators Manual
7. Select . This starts the calibration procedure.
7-8
Figure 7-3. Calibration Menu Configuration
The Calibration procedure is an automated process. The Controller automatically sets
pressure, dwells, and takes measurements. As the test runs, the Controller reads the
measurements from the modules and receives measurements data from the KN 3689
over the GPIB connection. The measurements are compared by the Controller. When
the calibration procedure is complete, a table with data and pass/fail information is
displayed on the screen. After the pass/fail information is shown on the screen, a new
screen appears that shows the deviation calculations.
hbx070.jpg