Fluke 4322 Operator's Manual page 49

Item Tab
Contains general system preferences.
Preferences

Screen Saver – Set when and what type of screen saver to display.
Sound – Set the system sound to Off, Low, Medium, or High. See "Sounds and
Alarm Volume" on page 2-21.
Time – Set the date and time. The time format can be changed from this menu.
On-Screen Instructions – Changes the amount of helpful text shown in the
message bar on the main menu. Standard shows all helpful text and Reduced
shows a minimalized amount of helpful text.
Security – Set the Controller security to On or Off. See "Security Levels" on
page 2-20.
Contains pressure control preferences.
Pressure Limits – Set the upper and lower pressure limits. See "Set the
Control

Pressure Limits and Control Limits" in Chapter 3.
Pressure Control – Set the Pressure Control Mode. See "Change the Pressure
Control Mode" in Chapter 3.
Dynamic Control with Jog Approach is only available as part of a Test Sequence.
Control Limits – Set the Control Limits. See "Pressure Limits and Control Limits"
in Chapter 3.
Jog Step – Set the Jog Step percentage. See "Jog Step Pressure Up or Down" in
Chapter 3.
4.0-305psi Supply - Set the default supply to use in the 4 psig to 305 psig range.
See "Internal and External Supply Setting" on page 2-6.
Cycle through the tabs not shown.
More >>>

Table 2-1. Settings Menu (cont.)
Function
Note
2
Setup
Controller Settings
2-17