Fluke 4322 Operator's Manual page 104

4322
Operators Manual
CALC:LIM:LOW[?] [limit]
CALC:LIM:UPP[?] [limit]
INP:TYPE[?] [type]
MEAS[x]:PRES?
MEAS[x]:PRES:ALL?
MEAS[x]:PRES:SLEW?
MEAS[x]:ZERO:VAL[?] [PZ,A,PZ,B,PZ,C]
MEAS:ZERO:STAT[?] [0|1]
OUTP:STAT[?] [0|1]
OUTP:MODE[?] [mode]
SENS:PRES:RES[?] [res]
SENS:PRES:MODE[?] [mode]
SENS:PRES:RANGE? [range]
SENS:PRES:REF:HEIG[?] [head]
SENS:PRES:REF:MED[?] [gas]
SOUR:PRES:CONT[?] [hold]
SOUR:PRES:LEV:IMM:AMPL[?] [targ]
SOUR:PRES:LEV:IMM:AMPL:AUTO[?] [targ]
SOUR:PRES:LEV:IMM:AMPL:VENT[?] [0|1]
SOUR:PRES:MODE[?] [mode]
SOUR:PRES:STAB[?] [stab]
STAT:OPER:COND?
STAT:OPER:ENAB[?] [flags]
STAT:OPER:EVEN?
SYST:BEEP:IMM
SYST:VER:LOGIC?
SYST:COMM:GPIB:SELF:ADDR[?] [addr]
SYST:DATE[?] [yyyy,mm,dd]
SYST:ERR?
SYST:HOUR?
SYST:KLOC[?] [0|1]
5-6
Table 5-2, List of Alphabetical Commands (cont.)
Command Quick Description
Read or set the upper limit
Read or set the lower limit
Read or set the supply input type.
Reads the pressure for the sensor.
Reads all 3 elements of the sensor.
Reads the slew rate.
Read or set the zero values.
Read or set the autozero state.
Read or set the current controller state.
Read or set the current controller operating mode.
Read or set the pressure resolution
Read or set the pressure measurement mode.
Read or set the range of the active sensor.
Read or set the head height.
Read or set the gas medium.
Read or set the 4322 control dead-band.
Read or set the set-point.
Read or set the set-point.
Read or set the vent status.
Read or set the 4322 controller mode.
Read or set the 4322 stability criteria.
Read the operation register
Read or set the operation enable mask
Read changes in the operation register
Beep the system beeper.
Read the programmable logic versions.
Read or set the 4322 device GPIB address.
Read or set the System Date.
Read the most resent error from the error queue.
Gets the operation time hour meters
Locks or unlocks the system keypad.