Subscribe to Our Youtube Channel
Related Manuals for Fluke TS 30
Summary of Contents for Fluke TS 30
- Page 1 ® Test Set Users Guide PN 2448469 October 2005 Rev. 1 10/08 ©2005, 2008 Fluke Corporation. All rights reserved. Printed in China. All product names are trademarks of their respective companies.
- Page 2 Networks warrants that software will operate substantially in accordance with its functional specifications for 90 days and that it has been properly recorded on non-defective media. Fluke Networks does not warrant that software will be error free or operate without interruption.
-
Page 3: Table Of Contents
Table of Contents Title Page Overview of Features ............................1 Registration ............................... 1 Contacting Fluke Networks ..........................1 Safety Information ............................2 Physical Characteristics ............................. 2 Mode Controls ............................2 Keypad ................................ 3 Dialing Keys ..............................3 Light Emitting Diodes (LEDs) ........................3 Line Cord ................................ - Page 4 TS30 Test Set Users Guide...
-
Page 5: Overview Of Features
Overview of Features Registration The TS30 Test Set is a portable handset used by Registering your product with Fluke Networks gives installers, repair technicians and other authorized you access to valuable information on product updates, personnel for testing of telephone lines and for troubleshooting tips, and other support services. -
Page 6: Safety Information
TS30 Test Set Users Guide Safety Information Physical Characteristics The following IEC symbols are used either on the test See Figure 1. set or in the manual: The TS30 housing is made of high-impact plastic. The unit provides rugged service and withstands the rough Warning: Risk of personal injury. -
Page 7: Keypad
Physical Characteristics The TONE/PULSE switch is on the inside of the hand FLASH: Pressing the FLASH key will cause a timed grip near the receiver. This switch selects the dialing interruption of the loop current. Some PBX setups or mode. telephone office switches may use this signal to put a call on hold or to activate some special function. -
Page 8: Line Cord
TS30 Test Set Users Guide Line Cord Dialing Note See Figure 4. If tone dialing is selected, the tones associated The TS30 comes with a line cord for connecting the test with each digit will be generated as its set to telephone lines. This line cord consists of one red respective key is pressed. -
Page 9: Last Number Redial
Fluke Networks. test lead. The red LED will light if the red test lead is connected to a more positive voltage than the black To replace the belt clip assembly: lead. -
Page 10: Line Cord Replacement
The line cord can be replaced by the user. To replace the line cord refer to the instructions that come with the replacement line cord. To obtain a replacement line cord contact your local distributor or Fluke Networks. Accessories To order accessories, contact your local distributor or Fluke Networks. -
Page 11: Specifications
Specifications Specifications Physical Measurements 10 in x 2.83 in x 3.34 in Electrical (25.5 cm x 7.2 cm x 8.5 cm) >14 dB (ref 600 Ω) Return Loss Weight 16.8 ounces (0.476 kg) Line Current Range 15 mA to 120 mA Environmental 275 Ω... - Page 12 TS30 Test Set Users Guide...
Need help?
Do you have a question about the TS 30 and is the answer not in the manual?
Questions and answers