Ipv6 Qppb Configuration Example - HP A6600 Configuration Manual

IPv6 QPPB configuration example

Network requirements
As shown in Figure
Figure 37 QPPB in an IPv6 network (on routers)
GE1/0/1
1::1/64
Router A
Configuration procedure
Enable IPv6 globally, and configure IP addresses for each interface (omitted)
1.
Configure Router A
2.
# Configure BGP.
<RouterA> system-view
[RouterA] bgp 1000
[RouterA-bgp] ipv6-family
[RouterA-bgp-af-ipv6] peer 168::2 as-number 2000
[RouterA-bgp-af-ipv6] network 1:: 64
[RouterA-bgp-af-ipv6] quit
[RouterA-bgp] quit
Configure Router B
3.
# Configure BGP.
<RouterB> system-view
[RouterB] bgp 2000
[RouterB-bgp] ipv6-family
[RouterB-bgp-af-ipv6] peer 168::1 as-number 1000
[RouterB-bgp-af-ipv6] peer 168::1 route-policy qppb import
[RouterB-bgp-af-ipv6] network 2:: 64
[RouterB-bgp-af-ipv6] quit
[RouterB-bgp] quit
# Configure a routing policy.
[RouterB] route-policy qppb permit node 0
[RouterB-route-policy] apply ip-precedence 4
[RouterB-route-policy] quit
# Enable QPPB on interface GigabitEthernet 1/0/1.
[RouterB] interface Gigabitethernet 1/0/1
[RouterB-GigabitEthernet1/0/1] bgp-policy destination ip-prec-map
37, all routers run BGP. Router B receives routes and sets the QPPB IP precedence.
AS 2000
AS 1000
S2/0/1
168::1/64
S2/0/1
168::2/64
GE1/0/1
2::1/64
Router B
112