Configuring Pq; Configuration Restrictions And Guidelines - HP FlexNetwork MSR Series Configuration Manuals

Step
2. Enter PW view.
3. Set the FIFO queue size
for the PW.

Configuring PQ

You can define a set of assignment rules in a PQ list and then apply the PQ list to an interface or
PVC. An assignment rule assigns a packet that meets a specific match criterion to a queue.
When a packet arrives, it is examined against match criteria in their configuration order.
•
When a match is found, the packet is assigned to the corresponding queue, and the matching
process ends.
•
If no match is found, the packet is assigned to the default queue.

Configuration restrictions and guidelines

•
If you apply multiple PQ lists to an interface or PVC, the PQ list last applied takes effect.
•
You must configure the rate limit for the queuing feature to take effect on the following
interfaces:
Tunnel interfaces.

Subinterfaces.

Layer 3 aggregate interfaces.

HDLC link bundle interfaces.

Command
•
Enter cross-connect PW view:
a. xconnect-group group-name
b. connection connection-name
c. peer ip-address pw-id pw-id [ in-label
label-value out-label label-value ]
[ pw-class class-name | tunnel-policy
tunnel-policy-name ] *
•
Enter VSI LDP PW view:
d. vsi vsi-name [ hub-spoke ]
e. pwsignaling ldp
f. peer ip-address [ pw-id pw-id ] [ hub |
no-split-horizon
class-name
tunnel-policy-name ] *
•
Enter VSI static PW view:
g. vsi vsi-name [ hub-spoke ]
h. pwsignaling static
i. peer ip-address [ pw-id pw-id ]
[ in-label label-value
label-value [ hub | no-split-horizon |
pw-class class-name | tunnel-policy
tunnel-policy-name ] * ]
qos fifo queue-length queue-length
66
Remarks
N/A
] [ pw-class
| tunnel-policy
out-label
The default setting is
75.
If the burst traffic is too
heavy,
queue length to make
queue scheduling more
accurate.
increase the