Displaying And Maintaining Traffic Policing, Gts, And Rate Limit - HP FlexNetwork MSR Series Configuration Manuals

To configure the rate limit for a PW:
Step
1. Enter system view.
2. Enter PW view.
3. Configure the rate limit
for the PW.
Displaying and maintaining traffic policing, GTS,
and rate limit
Execute display commands in any view.
Task
Display CAR configuration and statistics on
an interface.
Display CAR list information (centralized
devices in standalone mode).
Display CAR list information (distributed
devices in standalone mode/centralized
devices in IRF mode).
Display CAR list information (distributed
devices in IRF mode).
Command
system-view
•
Enter cross-connect PW view:
a. xconnect-group group-name
b. connection connection-name
c. peer ip-address pw-id pw-id
[ in-label label-value out-label
label-value ]
class-name | tunnel-policy
tunnel-policy-name ] *
•
Enter VSI LDP PW view:
d. vsi vsi-name [ hub-spoke ]
e. pwsignaling ldp
f. peer ip-address [ pw-id pw-id ]
[ hub | no-split-horizon ]
[ pw-class class-name
tunnel-policy
tunnel-policy-name ] *
•
Enter VSI static PW view:
g. vsi vsi-name [ hub-spoke ]
h. pwsignaling static
i. peer ip-address [ pw-id pw-id ]
[ in-label label-value out-label
label-value [
no-split-horizon | pw-class
class-name | tunnel-policy
tunnel-policy-name ] * ]
qos lr outbound
committed-information-rate
committed-burst-size
excess-burst-size ] ]
Command
display qos car interface [ interface-type interface-number ]
display qos carl [ carl-index ]
display qos carl [ carl-index ] [ slot slot-number ]
display qos carl [ carl-index ] [ chassis chassis-number slot
slot-number ]
54
Remarks
N/A
[ pw-class
N/A
|
hub |
cir
[ cbs By default,
[ ebs configured for a PW.
no rate limit is