HP FlexNetwork MSR Series Configuration Manuals page 101

Configuration procedure
1. Configure IP addresses for each interface. (Details not shown.)
2. Configure a BGP connection to Router B, and add the network 1.1.1.0/8 to the BGP routing
table on Router A.
<RouterA> system-view
[RouterA] bgp 1000
[RouterA-bgp] peer 168.1.1.2 as-number 2000
[RouterA-bgp] peer 168.1.1.2 connect-interface GigabitEthernet 1/0/2
[RouterA-bgp] address-family ipv4
[RouterA-bgp-ipv4] import-route direct
[RouterA-bgp-ipv4] peer 168.1.1.2 enable
[RouterA-bgp-ipv4] quit
[RouterA-bgp] quit
3. Configure Router B:
# Configure a BGP connection to Router A.
<RouterB> system-view
[RouterB] bgp 2000
[RouterB-bgp] peer 168.1.1.1 as-number 1000
[RouterB-bgp] peer 168.1.1.1 connect-interface GigabitEthernet 1/0/2
[RouterB-bgp] address-family ipv4
[RouterB-bgp-ipv4] peer 168.1.1.1 enable
[RouterB-bgp-ipv4] peer 168.1.1.1 route-policy qppb import
[RouterB-bgp-ipv4] quit
[RouterB-bgp] quit
# Configure a routing policy named qppb.
[RouterB] route-policy qppb permit node 0
[RouterB-route-policy-qppb-0] apply ip-precedence 1
[RouterB-route-policy-qppb-0] apply qos-local-id 3
[RouterB-route-policy-qppb-0] quit
# Enable QPPB on interface GigabitEthernet 1/0/2.
[RouterB] interface gigabitethernet 1/0/2
[RouterB-GigabitEthernet1/0/2] bgp-policy source ip-prec-map ip-qos-map
[RouterB-GigabitEthernet1/0/2] quit
# Configure a QoS policy named qppb.
[RouterB] traffic classifier qppb
[RouterB-classifier-qppb] if-match ip-precedence 1
[RouterB-classifier-qppb] if-match qos-local-id 3
[RouterB-classifier-qppb] quit
[RouterB] traffic behavior qppb
[RouterB-behavior-qppb] car cir 512 green pass red discard
[RouterB-behavior-qppb] quit
[RouterB] qos policy qppb
[RouterB-qospolicy-qppb] classifier qppb behavior qppb
[RouterB-qospolicy-qppb] quit
# Apply QoS policy qppb to incoming traffic on interface GigabitEthernet 1/0/2.
[RouterB] interface gigabitethernet 1/0/2
[RouterB-GigabitEthernet1/0/2] qos apply policy qppb inbound
[RouterB-GigabitEthernet1/0/2] quit
99