Setting The Fifo Queue Size; Setting The Fifo Queue Size For An Interface Or Pvc; Setting The Fifo Queue Size For A Pw - HP FlexNetwork MSR Series Configuration Manuals

•
MSR1002-4/1003-8S.
•
MSR2003.
•
MSR2004-24/2004-48.
•
MSR3012/3024/3044/3064.
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

Setting the FIFO queue size

FIFO is the default queue scheduling mechanism for an interface, and the FIFO queue size is
configurable. Queue length can affect delay and packet loss ratio.
For the queuing feature to take effect on a subinterface, you must configure the rate limit on the
subinterface.

Setting the FIFO queue size for an interface or PVC

Step
1. Enter system view.
2. Enter interface or PVC
view.
3. Set the FIFO queue size
for the interface or PVC.

Setting the FIFO queue size for a PW

Step
1. Enter system view.
Command
system-view
•
Enter interface
interface interface-type
interface-number
•
Enter PVC view:
a. interface
interface-number
b. pvc vpi/vci
qos fifo queue-length
queue-length
Command
system-view
65
Remarks
N/A
view:
N/A
atm
The default setting is 75.
If the burst traffic is too heavy,
increase the queue length to make
queue scheduling more accurate.
Remarks
N/A