Option L6/L6E Wiring; 115V Ac Interface Board Requirements - Allen-Bradley 1336 FORCE User Manual

Figure 2.28.

Option L6/L6E Wiring

100 100
20k
Typical of Each Input
0.22µf
0.15µf
0.33f
499k
49
19 20 21 22 23
TB3
Contacts shown are general, refer to Figure 2.24 for
Input Mode selection and recommended contact types.
Option L6/L6E – 115V AC Interface Board Requirements
Circuits used with Option L6/L6E must be capable of operating with high
= true logic. In the low state, circuits must generate a voltage of no more
than 30V AC. Leakage current must be less than 10 mA into a 6.5k ohm
load. In the high state, circuits must generate a voltage of 90–115V AC
+/–10% and source a current of approximately 20 mA for each input.
The L6/L6E option is compatible with these Allen–Bradley PLC modules:
1771–OW
1771–OWN
rev. level.)
Chapter 2
Installation/Wiring
L6, L6E Options
Typical
24 25 26 27 28 29 30
1771–OA
1771–OAD (contact factory for recommended series/
100
NOT
USED
681
5V
JP4
12V
90.9
ENC ENC
A A 12V RET
31 32 33 34 35 36
Common
User Supplied
Fuse
Fuse
115V AC
115V AC
2–41