Allen-Bradley 1336 FORCE User Manual page 173

Velocity Reference 2 LOW (Fraction)
[Vel Ref 2 Low]
This word supplies the fractional part of the
external velocity reference 2 when the ex-
ternal velocity control has been selected in
Logic Command (P52).
Velocity Reference 2 HI (Whole 32 bit)
[Vel Ref 2 Hi]
This word supplies the whole number refer-
ence 2 when the external velocity control
has been selected in Logic Command
(P52).
Velocity Scale Factor 2
[Vel Scale Fctr 2]
This parameter sets the gain multiplier that
will be used to scale velocity reference 2.
Velocity Trim LOW
[Vel Trim Low]
This word supplies the fractional number
part of a 32 bit velocity reference trim.
Velocity Trim Hi (32 bit)
[Vel Trim Hi]
This word supplies the whole number part
of a 32 bit velocity reference trim.
Velocity Reference Testpoint Data LOW
[Vel Ref TP Low]
This parameter indicates the LOW of the
32 bit value of the internal location selected
by the Vel Ref TP Sel, (P110).
Velocity Reference Testpoint Data HI
(32 bit)
[Vel Ref TP Hi]
This parameter indicates the HI 32 bit
value of the internal location selected by
the Vel Ref TP Sel, (P110).
Parameter Number 103
Parameter Type Sink
Display Units x
Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 65535
Parameter Number 104
Parameter Type Sink
Display Units +/– x.x rpm
Drive Units 4096 = Base Motor Speed
Factory Default + 0.0 rpm
Minimum Value – 8 x Base Speed
Maximum Value + 8 x Base Speed
Parameter Number 105
Parameter Type Sink
Display Units +/– x.xxxx
Drive Units 8192 = 1.000 gain
Factory Default +1.0000
Minimum Value –4.0000
Maximum Value +4.0000
Parameter Number 106
Parameter Type Sink
Display Units x Sec.
Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 65535
Parameter Number 107
Parameter Type Sink
Display Units +/– x.x rpm
Drive Units 4096 = Base Motor Speed
Factory Default 0.0 rpm
Minimum Value – 8 x Base Speed
Maximum Value + 8 x Base Speed
Parameter Number 108
Parameter Type Source
Display Units x
Drive Units 1 = 2
Factory Default 0
Minimum Value 0
Maximum Value 65535
Parameter Number 109
Parameter Type Source
Display Units +/– x.x rpm
Drive Units 4096 = Base Motor Speed
Factory Default +0.0 rpm
Minimum Value –8 x Base Speed
Maximum Value +8 x Base Speed
Chapter 5
Programming Parameters
1
/ Base Motor Speed
28
5–47