Exiting The Programming Mode; Setting Factory Defaults - Honeywell GSMX Installation And Setup Manual

GSMX Installation and Setup Guide

Exiting the Programming Mode

To exit the programming mode, press [N] in response to the "REVIEW?"
question. Then press [Y] to the "Exit Prog Mode?" question. Upon exiting,
the message "Checking Root File TX Path" will be displayed, and the
configuration file at the server is updated to log the changes made. When
complete, the message "DONE" is displayed to indicate the file was
successfully uploaded.
If critical configuration changes were made, such as the
mode of operation, the GSMX will reset to ensure that the
programming features are enabled.
If the file is not successfully uploaded, one of the following prompts will be
displayed. Follow the steps shown below until the upload is successful.
Display
GSM
Cannot Upload
Communicator has
Try Again?
not yet initialized.
Y/N_
Network problem,
Failed to Update
or you answered
Root File!
"N" to "Cannot
Upload Try Again?"
prompt.

Setting Factory Defaults

To reset the programming options to factory-default values, press [ESC] at
the "Exit Prog Mode?" prompt.
Set Default?
Press [Y] to reset factory default values.
Press [N] to cancel this function.
Y/N_
If you press [Y], all programmed values are reset to the original factory
settings.
PLEASE NOTE THAT THIS WILL ERASE ANY PASSWORD THAT MAY
HAVE BEEN ENTERED. After pressing [Y], the Create Password prompt
appears (see Programming step 4).
Description
Wait for SIGNAL (green) LED to
be lit.
Press [Y].
Initiate the Force Server Update
command by pressing the [0] key.
– 19 –
What to do