Setting Parameters - Mitsubishi Electric MELSEC iQ-R Series User Manual

6.8

Setting Parameters

Set parameters for the system and modules.
CW Configurator is connected to the actual system configuration
Read the actual system configuration to the Module Configuration Diagram of CW Configurator to set parameters.
[Navigation window]  [Module Configuration]
Precautions
RQ extension base unit, MELSEC-Q series extension base unit, or modules mounted on these extension base units cannot
be read. For the modules unable to be read, create the module configuration by dragging each module from the Element
Selection window and dropping it on the Module Configuration Diagram.
1.
Open the Module Configuration Diagram, and select
[Online]  [Read Module Configuration from PLC].
2.
The system parameter has been set automatically, and
the actual system configuration is displayed on the
Module Configuration Diagram.
3.
Double-click the CPU module, I/O module, and
intelligent function module shown to display the
parameter editor for the respective modules.
4.
After setting the parameters, click the [Apply] button.
6 PROCEDURE BEFORE OPERATION
45
6.8 Setting Parameters
6