Setting The Module; Initializing The C Controller Module; Setting Parameters - Mitsubishi Electric MELSEC iQ-R Series User Manual

8.2

Setting the Module

Initializing the C Controller module

A C Controller module is required to be initialized before the first operation.
For the method for initializing a module, refer to the following section.
Page 32 Initialization

Setting parameters

Set parameters for the C Controller module.
Connecting the C Controller module to the personal computer
Connect the personal computer (1) to the CH1 on the C Controller module (2) using an Ethernet cable.
(1)
Precautions
The IP address of the C Controller module and that of the personal computer are required to be set in the same segment. In
this operation example, the default IP address is set for the C Controller module (192.168.3.3); therefore, set '192.168.3.* (*:
except for 0, 3, and 55)' for the personal computer.
Set the subnet mask for the personal computer to '255.255.255.0'.
For how to change an IP address, refer to the following manual.
MELSEC iQ-R C Controller Module User's Manual (Application)
Starting CW Configurator to create a project
Operating procedure
1.
Select [Start]  [All Programs]  [MELSOFT]  [CW Configurator]  [CW Configurator].
2.
Select [Project]  [New].
3.
Check that "RCPU" and "R12CCPU-V" are selected, and click the [OK] button.
(2)
8 OPERATION EXAMPLE
8.2 Setting the Module
8
63