Setting Procedure - Mitsubishi Electric MELSEC iQ-R Series User Manual

Setting procedure

The setting procedure for a MELSEC-Q series module in CW Configurator is shown below.
• When CW Configurator can be connected to the actual system configuration, the configuration can be read
by selecting [Online]  [Read Module Configuration from PLC]. For modules of which configuration cannot
be read, drag each module from the Element Selection window and drop it on the Module Configuration
Diagram.
• To change "Points", "Start XY", "Control PLC Settings", or "CPU Module Operation Setting at Error
Detected", set the parameters in "System Parameter"
1.
Create a module configuration in accordance with the
actual configuration by dragging each MELSEC-Q
series module from the Element Selection window and
dropping it onto the Module Configuration Diagram.
2.
Set the parameters of each module.
Appendix 2 How to Use MELSEC-Q Series Modules
A
APPX
105