Sega Mushiking Owner's Manual page 53

「Mushiking#3-eng.doc」 最終印刷日時：2010/01/14 14:19:00
factory settings. The anode of the CRT itself will charge as time elapses,
generating high voltage that is very dangerous. The monitor should be used with
the Chassis, CRT, and PCB assembled. When repair, etc. is required at the time of
malfunctioning, be sure to send it in an assembled state. If it is disassembled, the
charged high voltage can be released, causing a very hazardous situation.
Therefore, under no circumstances should it be disassembled.
[!] CAUTION
● Static Electricity
Touching the CRT surface sometimes causes a slight shock. This is because the
CRT surfaces are subject to static and will not adversely affect the human body.
● Installation and Removal
Ensure that the Demagnetizer Coil, FBT (Fly-Back Transformer), Anode Lead, and
Focus Lead are not positioned close to the sheet metal work's sharp edges, etc.
and avoid damaging the insulated portions so as not to cause electric shock
and malfunctioning. (For the name of parts, refer to the figures above.)
(P. 46)
15-2 CLEANING THE CRT SURFACES AND THE MONITOR
COVER
[!] CAUTION
Observe the following points to prevent damage when cleaning accessory
surfaces.
● Remove smears using a dry, soft cloth (flannel, etc.). Do not use coarse gauze
or other harsh materials.
● For smear removing solvent, alcohol (ethanol) is recommended. When using
chemical detergent, be sure to follow the instructions below:
● Soak a soft cloth in a neutral household detergent diluted with water. Wring
the cloth well, and then clean down the surface.
● Do not use bleach or detergent that contains abrasive agents.
● Do not use alkaline chemical detergents such as "glass cleaner" available on
the market or solvents such as thinner, etc.
● Do not scrape or scratch surfaces using brushes, scouring pads, or other hard
cleaning utensils.
9/17