Table of Contents
Advertisement
Tools and Implements Required for the Work
1) Phillips screwdriver (for M4 screws)
2) Master key
3) Spanner with a jaw width of 24 mm (for M16 hexagon bolts)
(P. 14)
[1] SECURING IN PLACE (ADJUSTER ADJUSTMENT)
[!] WARNING
● Make sure that all the adjusters are resting on the floor. The cabinet may move
and cause an accident if the adjusters are not laid out properly.
● When aligning the adjusters, be sure to also secure the cabinet hold brackets
to prevent tipping. Failure to do so could result in injury or other hazards.
IMPORTANT
(STOP)
The adjusters are made of metal and therefore present a risk of damaging the
floor. Please keep this in mind when positioning the cabinet.
The cabinet is equipped with 4 casters and 2 adjusters.
After deciding on a location, bring the adjusters into direct contact with the ground and adjust the cabinet
so that it is completely level.
1.
Move the cabinet to the desired location. Make sure there is space in the back for air to flow.
2.
Insert the cabinet hold brackets into the adjuster bolts. (FIG. 6.1b) The cabinet hold brackets are the
same for the left and right.
3.
Bring the adjusters into direct contact with the floor. Use a wrench to align the height of the adjusters
until the cabinet is perfectly level. If the floor is level, the machine should be level with the casters
about 5 millimeters from the floor. (FIG. 6.1c)
4.
After making the final adjustments, fix the adjuster height by tightening up the adjuster nuts.
Tightening up the nuts will fix the cabinet hold brackets in place.
FIG. 6.1a Bottom View
1)
CABINET HOLD BRACKET (2)
2)
ADJUSTER (2)
3)
ADJUSTABLE CASTER (2)
4)
FIXED CASTER (2)
「Mushiking#1-eng.doc」 最終印刷日時：2010/01/14 14:16:00
15/27
Advertisement
Table of Contents
