Setup; Important Notes - Kollmorgen AKM Series Instruction Manual

Setup

Setup
15
15.1

Important notes

Only specialist personnel with extensive knowledge in the areas of electrical engineering /
drive technology are allowed to commission the drive unit of servo amplifier and motor.
Deadly voltages can occur, up to 900V. Risk of electric shock! Check that
all live connection points are safe against accidental contact.
Never undo the electrical connections to the motor when it is live. Risk of
electric shock! The residual charge in the capacitors of the servo amplifier
can produce dangerous voltages up to 10 minutes after the mains supply
has been switched off. Even when the motor is not rotating, control and
power leads may be live.
Measure the DC-link voltage and wait until it has fallen below 40V.
The surface temperature of the motor can exceed 100°C in operation.
Danger of light burns! Check (measure) the temperature of the motor.
Wait until the motor has cooled down below 40°C before touching it.
The drive performing unplanned movements during commissioning
cannot be ruled out.
Make sure that, even if the drive starts to move unintentionally, no danger
can result for personnel or machinery.
The measures you must take in this regard for your task are based on the
risk assessment of the application.
English - 52
04/2013
Kollmorgen
Servomotors AKM