Table of Contents
Advertisement
Installation -
Installation
1
5
Step 1 – PREPARING TO MOUNT THE CAMERA
Template Sheet
4
1.
2.
3.
4.
Step 2 – CABLING THE CAMERA TO EXTERNAL DEVICES
7
5.
Step 3 – INSTALLING THE CAMERA
6.
6
7.
8
8.
9
9.
The mounting surface must bear ve times the weight of your camera.
Do not let the cables get caught in improper places or the electric line cover
to be damaged. This may cause a breakdown or re.
For the installation process, remove the dome cover from the camera module
by loosening the three (3) screws on the dome. Use the wrench provided with
the camera.
Using the mounting template sheet or the camera itself, mark and drill the
necessary holes in the wall or ceiling.
Pass the wires through the mount bracket and make all necessary
connections.
a.
NETWORK CONNECTIONS – The camera supports a PoE power
connection. Use a PoE Switch to connect the camera using an Ethernet
cable for both data and power.
Power Requirements
POE IEEE 802.3af Class2
Power Consumption
Max. 5.2W
Attach the main body to the mount bracket by tightening the lock screw
using the six-angle wrench.
To use the camera's water proof wiring:
(1).
Install the LAN cable into
a
(2).
will be assembled to
with a 1/4 turn.
a
b
(3).
Thread
t
ightly to
.
c
b
Note: To ensure moisture seal, make sure the o-ring is in place between
(a) and (b). In extreme environments use of an outdoor rated sealer
is recommended.
Use the camera's 3-Axis gimbal to adjust the camera's tilt and angle. The
camera's maximum tilting angle is 70.
Assemble the dome cover over the camera body and detach the protecting
film from the dome bubble.
NETWORK
CONNECTION
.
b
a
c
Advertisement
Table of Contents
