Digital Watchdog MEGApix DWC-MV72Wi28A User Manual page 18

Network Setup -
Guide to Network Environment
Please con gure the IP Camera at the
installation site. You must determine your
network scenario in order to con gure the IP
Camera with the proper TCP/IP settings.
This tutorial will guide you through the
process. Before actually con guring the IP
Camera, determine settings to be applied.
Record those settings to be used to con gure
your IP Camera for reference.
When con guring your IP Camera, treat the
IP Camera as another PC on your network.
You will assign it several addresses and other
TCP/IP properties to match your current
network.
This step-by-step tutorial will teach what IP
addresses and network con gurations should
be assigned based on the network scenario.
Before you begin, locate any information and settings
1.
received from your Internet Service Provider (ISP). You may
need to refer to these IP addresses at a later time during the
con guration.
Current TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server (Option)
Static Dynamic
If you were not given any IP addresses or the ISP was responsible
for the setup and installation of your Internet connection, go to
step 2.
If you are not using a router on your network, your 'Current TCP/IP
Settings' (from the previous section) and 'Assigned IP Addresses
from My ISP' will be exactly the same.
You must determine whether the IP address is STATIC or
2.
DYNAMIC. At this moment, you are only concerned about the
ISP. Did they provide you with a STATIC or DYNAMIC address?
If you are unsure, contact your ISP.
Con gure your IP Camera's TCP/IP settings for network
3.
connectivity by selecting Setup from the main interface and
selecting TCP/IP located on the left of the Setup screen.
If prompted for ID and Password, use 'admin' for both entries.
4.
The default web port number is 80. If port 80 is blocked by
the ISP, a value between 1025 ~ 60000 should be used. If TCP
port 80 is blocked, consult the ISP
5. The following descriptions are several basic network
scenarios. Determine which scenario describes your network.
If your network does not match one of the scenarios below
and you are unsure how to setup your IP Camera, contact
your network administrator and then call our Support Center.
You cannot control the rectangular gray areas and only the ISP
has access to the devices.
18