Digital Watchdog DWC-MV72i4V Quick Start Manual

Quick Start Guide
DWC-MV72i4V / DWC-MV72i28V
Username: admin Password: admin
WHAT'S IN THE BOX
Mount Bolt &
QSG Manual 1 Set
Nut – 2pcs
Screw & Plastic
Manual CD 1 Set
Anchor – 2pcs
Template Sheet
for installing by 1 Set Torx Wrench
Bolt & Nut
Attention: This document is intended to serve as a quick reference page for initial set-up.
It is recommended that the user read the entire instruction manual for complete and proper
camera usage.
Tel: 866-446-3595 / 813-888-9555
Technical Support Hours:
9:00AM – 8:00PM EST, Monday thru Friday
Step 1 – PREPARING TO MOUNT THE CAMERA
1. The mounting surface must bear five times the weight of your camera.
2. Do not let the cables get caught in improper places or the electric line cover to
be damaged. This may cause a breakdown or fire.
3. For the installation process, remove the dome cover from the camera module
by loosening the three (3) screws on the dome. Use the wrench provided with
the camera.
4. Using the mounting template sheet or the camera itself, mark and drill the
necessary holes in the wall or ceiling.
Step 2 – CABLING THE CAMERA TO EXTERNAL DEVICES
5. Pass the wires through the mount bracket and make all necessary connections.
a. NETWORK CONNECTIONS – If you are using a PoE Switch, connect the
camera using an Ethernet cable for both data and power.
b. NETWORK CONNECTIONS – If you are using a non-PoE switch, connect
the camera to the switch using an Ethernet cable for data transmission and
use a power adapter to power the camera.
Power Requirements
DC 12V
PoE IEEE 802.3atPoE+ / PoE Class 2
Power Consumption
LED Off: 1.92W, 160mA
LED On: 2.7W, 230mA (IR models only)
1 Set
Step 3 – INSTALLING THE CAMERA
6. To use the camera's water proof wiring:
1 Set
(1).
Install the LAN cable into (a).
(2).
(b) will be assembled to (a)
with a 1/4 turn.
1 Set
(3).
Thread (c) tightly to (b).
Note: To ensure moisture seal, make sure the o-ring is in place between
(a) and (b). In extreme environments use of an outdoor rated sealer
is recommended.
7. Use the camera's 3-Axis gimbal to adjust the camera's tilt and angle. The
camera's maximum tilting angle is 70.
digital-watchdog.com
8. Assemble the dome cover over the camera body and detach the protecting film
from the dome bubble.
NETWORK
CONNECTION
POWER
c
b
a
Quick Start Guide
Template
Sheet
1
4
5
2
3
Reset
Button
Resetting the camera: To reset the camera, use the tip of a paper clip or
a pencil and press the reset button. Pressing the button for five (5) seconds
will initiate a camera-wide reset of all the settings, including network settings.