Table of Contents
Advertisement
Setup - Network Setup
Network Settings
10
10
1
Network Type
Subnet Mask, Gateway, DNS Server and all ports.
If you select the Dynamic Mode, the IP address will be
allocated automatically by DHCP equipment. If you click
the Apply button to update changes, the system will be
re-booted. In this case, you have to reconnect the camera
using new IP address.
2
IP Address
numbers separated by dots and the range of each number
is from 0 to 255.
3
Subnet Mask
Default Gateway
4
Default the Gateway IP Address. Format is same as the IP
address.
5
Preferred DNS Server
IP address.
Alternate DNS Server
6
same as the IP address.
HTTP Port
7
The HTTP port can be set to 80 which default or in between
1025 to 60000.
HTTPS Port
8
The HTTPS port can be set to 443 which default or in betwe
-en1025 to 60000.
RTSP Port
9
The RTSP port can be set to 554 which default or in between
1025 to 60000.
10
If the network type is dynamic, the IP address is changed in
below cases. Therefore, the IP address needs to be searched
again, and the camera needs to be reconnected in these
cases.
- When the camera power is
- After Firmware update, Default set and reboot.
4
1
2
3
4
5
6
7
8
7
9
8
9
Advertisement
Table of Contents
