Indicators And Display Messages - Sharp MX-M200D Operation Manual

INDICATORS AND DISPLAY MESSAGES

If one of the following messages appears in the display, take prompt action as instructed by the message.
Message
(Maintenance icon)
(Developer replacement required
icon)
Maintenance required. Call for
service.
Call for service.
(Toner cartridge replacement
required icon)
Check the toner cartridge.
Remove paper from the output tray
and press [OK].
Load < > paper into tray < >.
Memory is full.
< >: Tray number
< >: Size of paper that should be loaded
28
It is time for regular maintenance. Contact your authorised service
representative.
Developer is required. Contact your authorised service representative as
soon as possible.
Maintenance required soon. Contact your authorised service
representative.
– Turn off the power and then turn it back on. If this does not clear the
message, write down the 2-digit main code and 2-digit sub-code
(" -
service representative.
The toner cartridge must be replaced soon.
Check to see if the toner cartridge has been installed properly.
The number of sheets in the output tray (centre tray or top tray) has
reached the limit. Remove the paper.
The paper size specified for the tray is different from the actual size.
(Page 21)
The memory became full while scanning the originals. Press the [START]
key ( ) to copy only the originals that have been scanned, or press the
[CA] key to cancel the job.
An optional memory board (AR-SM5) can be installed to increase the original
scanning capacity. Memory can be expanded to a maximum of 272 MB
(256 MB of expansion memory).
"), turn off the power, and promptly contact your authorised
Action