Indicators And Display Messages - Sharp AL-1633 Operation Manual

INDICATORS AND DISPLAY
MESSAGES
If one of the following indicators lights up or one of the following messages appears in the display, check the
meaning of the indicator or message in the following table and take appropriate action.
TD cartridge replacement
required indicator
Paper required indicator
Indication
TD cartridge
replacement
required indicator
Drum cartridge
replacement
required indicator
Paper required
indicator
Misfeed indicator
ORIGINAL SIZE indicator
PAPER SIZE indicator
[CH] appears in display
Letters and numbers appear
in the display
When "Use close paper size" is disabled
A3
A4
A4
A5
B4
EXTRA
Drum cartridge replacement required indicator
Misfeed indicator
Steadily Replacement of TD cartridge will be needed soon. Prepare
lit a new cartridge.
Blinking TD cartridge must be replaced. Replace it with a new one.
Steadily Replacement of drum cartridge will be needed soon.
lit Prepare a new cartridge.
Blinking Drum cartridge must be replaced. Replace it with a new one.
The tray is out of paper. Load paper. It is also possible that
Steadily
the tray is not inserted completely into the machine. Make
lit
sure it is inserted correctly.
A paper misfeed has occurred. Remove the misfeed as
Blinking
explained in "MISFEED REMOVAL".
The original is not placed in the correct orientation. Rotate the
Blinking original so that it is in the same orientation as the blinking
ORIGINAL SIZE indicator.
A blinking paper feed location means that the size of paper
loaded in the tray is different from the paper size setting for the
tray. Change the paper size setting.
To clear the display, do one of the following:
Blinking
• Use the [TRAY SELECT] key (
selection.
• Open and close the tray.
• Press the [CLEAR ALL] key (
Steadily The front cover or the side cover is open. Close the front
lit cover or the side cover.
The drum cartridge or TD cartridge is not installed correctly.
Reinstall the drum cartridge or TD cartridge. If [CH] still
Blinking blinks in the display after reinstalling the drum cartridge or
TD cartridge, contact your authorised service
representative.
Turn off the power switch, wait about 10 seconds, and then
turn on the switch again. If this does not clear the message,
write down the code that appears and then unplug the
power cord and contact your authorised service
representative. Tell your authorised service representative
what code appeared and the circumstances under which it
appeared.
The PAPER SIZE indicator on the operation panel will blink.
You can press the [TRAY SELECT] key (
manually, or load paper in the bypass tray and press the
[ON LINE] key ( ) to begin printing.
Display
Cause and solution
) to change the tray
).
) to select a tray
Page
61
62
17
54
16
5
19
–
61
–
Online
manual
53