Indicators And Display Messages - Sharp AR-M160 Operation Manual

INDICATORS AND DISPLAY
MESSAGES
If one of the following indicators lights up or one of the following messages appears in the display, check the
meaning of the indicator or message in the following table and take appropriate action.
Toner cartridge replacement required indicator
Paper required
indicator
Indication
Maintenance
indicator
Developer
replacement
required indicator
Toner cartridge
replacement
required indicator
Paper required
indicator
Misfeed indicator
ORIGINAL SIZE indicator
PAPER SIZE indicator
[CH] appears in display
Letters and numbers appear
in the display
"FUL" appears in the display
When "Use close paper size" is
disabled
ORIGINAL PAPER
SIZE SIZE
11 17
X
8½ 14
X
8½ 11
X
8½ 5½
X
8½ 11
X
EXTRA
Misfeed location indicator lights up at
the optional 2 x 250-sheet/250-sheet
paper feed unit
62
Maintenance
indicator
Steadily Service by an authorized SHARP service technician is
lit required.
Steadily Developer is required. Contact your SHARP service center
lit as soon as possible.
Steadily Replacement of toner cartridge will be needed soon.
lit Prepare a new cartridge.
Blinking Toner cartridge must be replaced. Replace it with a new one.
The tray is out of paper. Load paper. It is also possible that
Steadily
the tray is not inserted completely into the machine. Make
lit
sure it is inserted correctly.
A paper misfeed has occurred. Remove the misfeed as
Blinking
explained in "MISFEED REMOVAL".
If the ORIGINAL SIZE indicator blinks when margin shift is
Blinking selected, rotate the original so that it is in the same
orientation as the blinking ORIGINAL SIZE indicator.
There is no appropriate paper. Load appropriate paper in a
Blinking （Ｐ）
paper tray.
Steadily The front cover or the side cover is open. Close the front
lit cover or the side cover.
The toner cartridge is not installed correctly. Reinstall the toner
Blinking cartridge. If [CH] still blinks in the display after reinstalling the
toner cartridge, contact a SHARP service center.
Write down the code that appears and then unplug the
power cord and contact your dealer. Tell your dealer what
code appeared and the circumstances under which it
appeared.
Data is being held in memory. Print the data or clear it from
memory.
The PAPER SIZE indicator on the operation panel will blink.
You can press the [TRAY SELECT] key (
manually, or load paper in the bypass tray and press the
[ON LINE] key ( ) to begin printing.
The lower side cover of the 2 x 250-sheet/250-sheet paper
feed unit is open. Close the lower side cover.
Developer replacement required indicator
Display
Misfeed indicator
Cause and solution Page
–
–
–
70
14
63
36
13
–
70
–
33, 35
) to select a tray Online
manual
–