Resetting The Drive/Peripherals; Setting Factory Defaults; Setting Powerflex 750-Series Drives/Peripherals To Factory Defaults - Allen-Bradley PowerFlex 20-HIM-A6 User Manual

Chapter 4 Using the HIM
Resetting the Drive/
Peripherals

Setting Factory Defaults

40
The drive or any of its connected peripherals can be reset by removing and
restoring power to the drive (power cycling). If this is not convenient or cannot
be done because of application circumstances, the HIM can be used to reset the
drive/peripherals. Follow these steps to reset the drive or any of its peripherals.
1. Access the Status screen (see
2. Use the or
reset (for example, Port 00 for the host drive).
3. Press the key to display its last-viewed folder.
4. Use the or
5. Use the or
6. Press the (Enter) key to display a popup box asking if you want to
reset the device.
7. Press the ENTER soft key to affirm and reset the device, or press the ESC
soft key to cancel.
The procedure to set a PowerFlex 750-Series drive and its connected peripherals
to factory defaults is slightly different than the procedure used for a PowerFlex 7-
Class drive and its peripherals. See the respective subsection for instructions.

Setting PowerFlex 750-Series Drives/Peripherals to Factory Defaults

1. Access the Status screen (see
2. Use the or
parameters you want to set to factory defaults (for example, Port 00 for the
host drive or the respective port number for one of the drive's connected
peripherals).
3. Press the key to display its last-viewed folder.
4. Use the or
5. Use the or
6. Press the (Enter) key to display the Set Defaults popup box (see
examples below).
Stopped
0.00 Hz
Port 00 Set Defaults
Host and Ports (Preferred)
This Port Only
ESC
For Host Drive
Rockwell Automation Publication 20HIM-UM001E-EN-P - May 2017
Figure 6).
key to scroll to the Port of the device you want to
key to scroll to the DIAGNOSTIC folder.
key to select Reset Device.
Figure 6).
key to scroll to the Port of the device whose
key to scroll to the MEMORY folder.
key to select Set Defaults.
AUTO Stopped
F 0.00 Hz
Port xx Set Defaults
This Port Only
INFO
ESC
For Connected Peripheral
AUTO
F
INFO