Setting Display Flashing For Fault Indication - Allen-Bradley PowerFlex 20-HIM-A6 User Manual

Chapter 4 Using the HIM
Setting Display Flashing for
Fault Indication
42
Whenever a fault for the host drive or any of its connected peripherals is
detected, a popup Fault Display screen (see
Status Bar flashes to alert the operator. However, you can change the flash mode
for the Fault Display screen to one of the following modes:
• Flash Bklite; selects the entire LCD screen to flash.
• Flash Status (default); selects only the Status Bar (item 1,
• Flash None; selects no flashing for the Fault Display screen.
Follow these steps to change the flash mode for the Fault Display screen.
1. Access HIM Parameter 04 - [Fault Dspy Type] using either the Direct
Parameter Access method
(page 45).
2. Press the EDIT soft key to display the Edit Fault Dspy Type popup box.
Stopped
0.00 Hz
Edit Fault Dspy Type
Flash Bklite
0 << 2
ESC ? ?
3. Use the and
erroneous entry, use the
4. Press the ENTER soft key to enter your selection and return to the
parameter screen.
Rockwell Automation Publication 20HIM-UM001E-EN-P - May 2017
page 32) appears. By default, only the
(page 44) or Alternate Linear List method
AUTO
F
0
ENTER
soft keys to select the desired flash mode. To delete an
soft key.
Figure 3) to flash.