Changing Access Code-Protected Drive/Peripheral Parameters - Allen-Bradley PowerFlex 20-HIM-A6 User Manual

Chapter 4 Using the HIM
60

Changing Access Code-protected Drive/Peripheral Parameters

When the host drive is access code-protected, parameter settings for the drive and
its connected peripherals can be viewed—but not changed until after the correct
access code value is entered.
When attempting to edit a parameter value while logged out, the HIM will
prompt you for the access code before allowing access.
Access code protection also applies to:
• Drive start-up procedure
• Factory defaults
• User sets
• CopyCat function
Follow these steps to edit access code-protected parameters.
1. Access the Status screen (see
2. If Port 00 (host drive) is not shown above the ESC soft key, use the
or key to scroll to Port 00.
3. Press the key to display its last-viewed folder.
4. Use the or
5. Use the or
6. Press the (Enter) key to display the Enter Password popup box.
Stopped
0.00 Hz
Enter Password
0 << 65535
ESC
7. Use the numeric keys to enter the existing access code value.
soft key to delete an erroneous entry.
Use the
8. Press the ENTER soft key to enter the existing access code.
Thereafter, any parameter setting can be changed.
Rockwell Automation Publication 20HIM-UM001E-EN-P - May 2017
Figure 6).
key to scroll to the PROPERTIES folder.
key to select Log In.
AUTO
F
0
ENTER