Allen-Bradley RediPANEL Installation Instructions

Introduction

Mechanical Installation

1
RediPANEL Mounting System
This document covers the installation procedure to use when
mounting the following modules in a panel:
• Keypad Module (2705-K11Cx)
• NEMA Module (2705-P2xCx)
• 8/16/32 Type 800A Module (2705-P11*, -P21*, -P31*)
This procedure replaces a mounting bracket arrangement with studs
and nuts.
Hazardous voltage. Contact with voltage may cause
ATTENTION
death or serious injury. Always disconnect power to
sign prior to servicing.
!
The following procedure replaces the mechanical installation which
appears in the following publications:
• 2705-ND002 - RediPANEL Keypad Modules
• 2705-800 - RediPANEL Push Button Modules
During module installation, refer to the accompanying mounting
template for exact dimensions.

To install the module:

If you are installing the module in an existing cutout,
IMPORTANT
skip to step 3.
1. Cut an opening in the panel approximately
149 x 219 mm (h x w) or 5.86 x 8.61 in (h x w)
2. Drill four or six (as required) 0.250 in (6.4 mm) diameter holes
for the top and bottom mounting studs in the positions indicated
on the template.

Installation Instructions

Publication 2705-IN006A-EN-P - September 2003