Resetting the DTAM Micro
Use the reset function to reset the DTAM Micro after DIP switch changes or
a configuration change using the Mode Menu.
To reset the DTAM Micro:
1. From the Mode Menu select 1 Reset.
1 Reset
2 Com-Port
You are prompted:
2. Press [1] on the keypad to initiate the reset.
The DTAM Micro resets. This has the same effect as turning the power
off and on. The DTAM Micro performs the self diagnostic tests and
powerup displays as described in the previous section.
Chapter 3
Initial Setup and Mode Menu
3 Special
4 Other
1 = Reset DTAM Micro
0 = Abort
3–5