Table of Contents
Advertisement
<Configuration example>
Overview: Enable the authentication function for Port 1.
Enable the periodic client re-authentication. Change the number of seconds
to wait before requesting to reattempt authentication so that the value
obeys the switch configuration. Set the number of seconds to wait before
requesting to reattempt authentication to 6000 seconds.
1. Move to the interface configuration mode for Port 1.
2. Enable the authentication function for Port 1.
3. Enable periodic re-authentication to the client for Port 1.
4. Make change to align the number of seconds to wait before
requesting to reattempt authentication for Port 1 with the switch
configuration.
5. Set the number of seconds to wait before requesting to reattempt
authentication for Port 1 to 6000 seconds.
M24eG> enable
M24eG# configure
M24eG(config)# interface gi0/1
M24eG(config-if)# dot1x port-control auto
M24eG(config-if)# dot1x re-authentication
M24eG(config-if)# dot1x re-auth-timer local
M24eG(config-if)# dot1x timeout re-authperiod 6000
M24eG(config-if)# end
M24eG#
Fig. 4-11-2. Configuration example of IEEE802.1X port-based authentication
297
･･･１
･･･２
･･･３
･･･４
･･･５
Advertisement
Table of Contents
