Appendix E: Firmware Change In Lcu 5350 - Assa Abloy VingCard Essence User Manual

Appendix E: Firmware change in LCU 5351
If a lock needs to have its firmware upgraded due to new firmware features etc,
follow the steps below:
1. Choose Upload firmware in the Lock Service 3G software
2. Mark the applicable lock firmware (and if you have touchpad, move the cursor
to be over the Upload button).
3. Connect the service cable to the lock; after a few seconds, the lock LED will
be green. Step 4 below must be performed directly after this
4. Click Upload; a progress bar will show how the upgrade proceeds. When the
upgrade is complete, a message will be shown.
1)
Always make sure that the lock firmware which is already included in Lock Service
3G is the latest version. If it is not, see the appendix about firmware upgrade in
Setup manual Visionline for information on how to prepare for lock firmware upgrade,
then choose Download firmware in Lock Service 3G to download the firmware
from the Visionline server to Lock Service 3G. It is also possible to browse to the
firmware file directly from the Upload firmware dialog, but it is recommended
to go via Visionline.
2)
If Upload is not clicked within 4 seconds, there will be a timeout and the
service cable must be disconnected and then connected again.
ASSA ABLOY Hospitality
61
1)
.
2)
.
66 1000 023-4