Assa Abloy VingCard Essence User Manual page 57

ASSA ABLOY Hospitality
Figure D16
Figure D17
Figure D18
Figure D19
18.To match the B-measurement of the
door leaf, it is possible to increase the
length of the LCU in order to reach the
*)
sprocket inside the Essence cassette.
This can be done by adding spacers
(expansion modules), which consist
of two halfs sliding into the slot on
the back of the LCU. The two halfs will
meet and by a "snap-lock" functionality
lock onto the LCU. Additional spacers
can be added on top of the other
spacers.
*) The sprocket is only partly locking the LCU in
place after installation.
19.Connect the lock case cable to the
Essence cassette (I in Figure D17).
20.Snap the lock case cable into the cable
gateway in the endnode housing (II in
Figure D17).
21.Fasten the fire-retardant material (55 x
70 x 0,9 mm) / (2 11/64)'' x (2 3/4)'' x
(1/32)'' ) in the area marked with III in
Figure D17.
Important before mounting the
Essence cassette in the door:
Make sure that the LCU cable is well
positioned in the space marked with
IV in Figure D17, to avoid pinching
of the cable.
22.Insert the Essence cassette into
the door.
23.Loose the bracket with a wrench (8 mm)
until it moves freely.
57
66 1000 023-4