Assa Abloy VingCard Essence User Manual page 30

ASSA ABLOY Hospitality
Figure 34
Figure 35
Figure 36
- A more secure way; fix the cylinder in
place by using the fixing-screw tool kit.
Use the L-shaped Allen key to lock the
headless fixing screw (cylinder screw
is turned upside down) to the T-shaped
tool as illustrated in Figure 34. Using the
T-tool, screw the fixing screw in place as
shown earlier to fix the cylinder in place.
Make sure that the cylinder fixing screw
is tightened in the cylinder. Release the
T-tool from the fixing screw by holding
the T-tool rigid while turning the Allen
key counter-clockwise until the Allen key
is released from the screw; then unscrew
the T-tool.
12. After installation of the cylinder, fix for
ANSI (DA) and ANSI (DB) the face plate
to the lock case after installation of
the cylinder.
13. Assemble the Essence cassette (8)
before installation.
14. Depending on whether the handing is
left or right (see details here), the fire
shield plate shall be attached on the
opposite side of the LCU (the drawing
shows right handing).
15.To match the B-measurement of the
door leaf, it is possible to increase the
length of the LCU in order to reach the
*)
sprocket inside the Essence cassette.
This can be done by adding spacers
(expansion modules), which consist
of two halfs sliding into the slot on the
back of the LCU. The two halfs will meet
and by a "snap-lock" functionality lock
onto the LCU. Additional spacers can
be added on top of the other spacers.
*) The sprocket is only partly locking the LCU in
place after installation.
30
66 1000 023-4