Command Class Firmware Update Meta Data, Version 5 - Assa Abloy Yale NTM612-ZW3 Manual

Command Class Firmware Update Meta Data, Version 5*

* This command class requires security.
Yale Z-Wave Plus ™ locks support over-the-air (OTA) upgrading of 2 firmware
targets:
1. Firmware Target 0: Z-Wave™ chip
2. Firmware Target 1: The lock main processor
Firmware Target 0 is used to determine the correct Z-Wave™ processor image to
download. ID 1 is always 0xA5, to signal this is an ASSA ABLOY Z-Wave™ image,
and ID 2 is specific to the region, with the lower nibble being 0x0 and the upper
nibble being the value in Table 4 - Region-Specific Values for Firmware ID 0.
Eventually the lower nibble will be used to separate builds within a specific region,
but this will also be 0 for now, since there is only a single build of firmware.
Table 4 - Region-Specific Values for Firmware ID 0 (Upper Nibble)
Region Value
ANZ 0x1
CN 0x2
EU 0x3
HK 0x4
IL 0x5
IN 0x6
JP 0x7
KR 0x8
RU 0x9
US 0xA
Firmware 1 target will depend on which version of the lock is in use (mapped to the
Product Type ID).
• For NTM612/617/622/627/632/637/642/647-ZW3 (2nd Generation Mortise
Locks) Firmware 1 ID = 0x8100
After an OTA is performed (a Firmware Update Status Report should return with
successful), there is an additional step internally where we write/apply the image to
the lock/module. When the image is being applied to the lock, the lock is
15