Agilent Technologies 1290 Infinity User Manual page 255

Table 8 Agilent 1200 Infinity Series Interfaces
Module
G4227A Flex Cube
G4240A CHIP CUBE
1
Requires a HOST module with on-board LAN (e.g. G4212A or G4220A with minimum firmware B.06.40 or C.06.40) or with
additional G1369C LAN Card
The detector (DAD/MWD/FLD/VWD/RID) is the preferred access point for control via
N O T E
LAN. The inter-module communication is done via CAN.
• CAN connectors as interface to other modules
• LAN connector as interface to the control software
• RS-232C as interface to a computer
• REMOTE connector as interface to other Agilent products
• Analog output connector(s) for signal output
1290 Infinity Quaternary Pump User Manual
CAN LAN/BCD LAN
(optional) (on-board)
2 No No
2 Yes No
Hardware Information
RS-232 Analog APG
Remote
No No No
Yes No Yes
12
Interfaces
Special
CAN-DC- OUT for CAN
slaves
2
CAN-DC- OUT for CAN
slaves
THERMOSTAT for
G1330A/B (NOT
USED), K1330B
255