Wiring - SMC Networks EX500 Series Instruction Manual

Wiring

Output wiring
Connect output devices to the output connectors.
EX9-OET1/EX9-OET2/EX9-OEP1/EX9-OEP2 output connectors
M12, 5-pin, socket
Connector on cable side: Ex; OMRON Corp.,
XS2H, XS2G. etc., and Franz Binder GmbH,
Series 713 and 763.
Model No. EX9-OET2/EX9-OEP2
Pin No.
NPN output
Output connector Output connector
No.0
Power supply Power supply
1
( DC24V ) ( DC24V )
2 Output ( OUT1 )
3 NC
4 Output ( OUT 0 ) Output ( OUT 1 )
5 NC
Two outputs are available with only output connector No. 0.
NOTE
Mount a waterproof cap to each unused connector. The proper use of waterproof cap
can achieve IP65 Enclosure. ( Tightening torque for M12: 0.1Nm )
34
EX9-OET1/EX9-OEP1
PNP output
Output connector Output connector
No.1 No.0
NC
NC Output ( OUT 1 )
Power supply Power supply
NC
( GND )
Output ( OUT 0 ) Output ( OUT 1 )
NC NC
NC: Not connected
Power supply wiring
When combining EX9-OEP1 ( or EX9-OEP2 ) and EX9-PE1 and using external power
supply, connect the power supply to the power input connector of EX9-PE1.
When selecting power supply, refer to "Handling precautions" ( page 3 ) in this manual.
1 2 EX9-PE1 power supply connector No.0
5
M12, 5-pin, reverse key, socket
4 3 Keep the waterproof cap mounted on power supply connector No.0 while using
Note
EX9-PE1. This connector is prepared supplementarily and not used normally.
EX9-PE1 power input connector No.1
M12, 5-pin, reverse key, plug
No.1
Cable side: Hans Turck GmbH & Co., WAKW series
NC
NC
( GND )
NC
Pin No.
1 Power supply for output devices ( DC24V )
2 Power supply for output devices ( 0V ) [Power supply for output devices ( 0V ) ]
3 [Power supply for sensor ( DC24V ) ]
4 [Power supply for sensor ( 0V ) ]
5
Ground
Note: Each signal of connector No.0 is connected to corresponding signal of connector No.1.
The pins whose applications are shown in brackets [ ], are prepared supplementarily and
not used normally.
25.5
43
2 1 1
5
3 4
4
Power input Power supply
connector No.1 connector No.0
Power input connector No.1
Power supply for output devices ( DC24V )
[Power supply for sensor ( DC24V ) ]
[Power supply for sensor ( 0V ) ]
[Ground]
4
3
1
5
2
M12
2
5
3
Power supply connector No.0
35