Display; Input Unit Manifold Part Names - SMC Networks EX500 Series Instruction Manual

Display

SI unit for SV series valves ( EX500-S
Power LED
Communication LED
SI unit for VQC series valves ( EX500-Q
Communication LED
Power LED
Common to EX500-S 01/EX500-Q
Display
Power LED Lights on: Power to solenoid valves/output is supplied at the
specified voltage.
Lights off: Power to solenoid valves/output is not supplied at
the specified voltage. ( Voltage dropped to lower
than 20V. )
Communication Lights on: Receiving data from GW
LED Lights off: No received data
24
01 )
)
Description

Input Unit Manifold Part Names

The Input unit manifold consists of Input unit, input block (s), end block and DIN rail.
The input block up to 8 can be connected ( 16 points ).
Any combination of input blocks ( for M8 connector, M12 connector and 8-point-
integrated type ) is acceptable.
Note Do not mix sensor input specifications ( PNP and NPN ) .
Figure shows the configuration when only input blocks for M8 connector are connected.
No. Part name
1 Input unit Unit to communicate with GW unit or SI unit.
2
Communication To be connected with branch cables from GW unit or
connector SI unit ( branch cable with M12 connector ) ( Note1 )
3 Power LED Indicates the power supply status. ( Note2 )
4 Input block Unit for sensor signal input.
5 Sensor connector Connects with sensor. ( Note1 )
6 Indicator LED Indicates sensor signal status. ( Note2 )
7 Marker To be used for writing input No. etc.
8 End block Composes the end of Input unit manifold.
9 DIN rail To be mounted with Input unit manifold.
Note1: For wiring method, refer to subsection "Wiring" ( page 29 ) of section "Input Unit
Manifold" in this manual.
Note2: For display, refer to "Display" ( page 30 ) in section "Input Unit Manifold" in this manual.
Application
25