Dimensions; Mounting - SMC Networks EX500 Series Instruction Manual

EX9 Series General Purpose Output Block Part Names (continued )
2. EX9-PE1
VQC series
SI unit for
general purpose
output block
( EX500-Q
No. Part name
1 Power supply connector Unused
Power input connector Supplies power for output devices. ( Note1 )
2
Power LED Indicates the power supply status. ( Note2 )
3
Note1: For wiring method, refer to subsection "Wiring" ( page 34 ) of section "EX9 Series
General Purpose Output Block" in this manual.
Note2: For display, refer to subsection "Display" ( page 37 ) in section "EX9 Series General
Purpose Output Block" in this manual.
Dimensions ( unit: mm )
1. EX9-OET1/EX9-OET2/
EX9-OEP1/EX9-OEP2
21.2
59.8
21
26.7
32
02 )
Application
2. EX9-PE1
21.2
59.8

Mounting

The mounting and removing methods of each SI unit are as shown below.
M3 18 : 2 pcs.
( Hexagon socket head
cap screw ( with spring washer ))
NOTE
Holding with hand so that there will be no gap between units and tighten the bolts.
Be sure to tighten each bolt by specified tightening torque.
( Tightening torque: 0.6Nm )
Dimensions when general purpose output block is connected
13
PWR PWR
L dimensions
No. of output block stations
L1 [mm]
L2 [mm]
L3 [mm]
The above dimensions show those when one unit of power block ( width: 21mm ) is
Note
combined. For details, refer to the instruction manuals, technical data, etc. of EX9
21
26.7
series general purpose output block.
Supply/exhaust block assembly,
end plate R, power block, or other
EX9 series general purpose output block
L1
L2
L3
PWR
PWR
COM
0 0 0 0 0 0
1 1 1 1 1 1
PWR
EX500
series
1 2 3 4
83 104 125 146
72 93 114 135
67 88 109 130
Power block or EX9 series
general purpose output block
Tie-rod: 4 pcs.
SI unit for general purpose
output block ( EX500-Q 02 )
0 0
1 1
Mounting hole for:
1.5
M4 places
5 6 7 8
167 188 209 230
156 177 198 219
151 172 193 214
33