Display; Ex9 Series General Purpose Output Block Part Names - SMC Networks EX500 Series Instruction Manual

Wiring (continued )
Correspondence between input number and input block
Input block up to 8 can be connected ( 16 points ).
Input numbers are 0 - 15 from Input unit side.
Input unit 0
0
1
1

Display

Settings for display
Display
Power LED Lights on: Power for input and controlling GW is supplied.
Blinks: Under short circuit protection ( abnormal status ).
As the short circuit protective function is operating, the
power is not supplied.
To cancel blinking, turn off and return the power to GW unit.
Lights off: Power for input and controlling GW is not supplied.
Indicator Lights on: Sensor signal input ON ( logical "1" )
LED Lights off: Sensor signal input OFF ( logical "0" )
30
2 4 6 8 10 12 14
0 0 0 0 0 0 0
1 1 1 1 1 1 1
3 5 7 9 11 13 15
Power LED
Indicator LED
Description

EX9 Series General Purpose Output Block Part Names

The EX9 series general purpose output block is the unit to operate solenoid valve, relay,
etc. in combination with VQC series valve and applicable SI unit.
There are two types ---- one type is for low wattage load ( EX9-OET1 or EX9-OET2 ) that
outputs signals by receiving power supply from SI unit, and the other type is for high
wattage load ( EX9-OEP1 or EX9-OEP2 ) that outputs signals by receiving power supply
from outside. The type for high wattage load is used in combination with the power block
( EX9-PE1 ) connected with external power supply. As the low-wattage-load type is
powered from SI unit, the wattage of load is limited to 1.0W ( Note1 ). For a load up to
12W, use the power block and the high-wattage-load type.
Note1: When connected with EX500 series.
1. EX9-OET1/EX9-OET2/EX9-OEP1/EX9-OEP2
VQC series
SI unit for
VQC series
( EX500-Q
No. Part name
1 Output connector Connects with output device. ( Note1 )
Indicator LED Indicates the output status. ( Note2 )
2
Note1: For wiring method, refer to subsection "Wiring" ( page 34 ) of section "EX9 Series
General Purpose Output Block" in this manual.
Note2: For display, refer to subsection "Display" ( page 37 ) of section "EX9 Series General
Purpose Output Block" in this manual.
02 )
Application
31