Renishaw RMP400 Installation Manual page 35

Multiple probe mode (omitted for "radio on")
(see "Multiple probe mode settings" to view all 16 choices)
Mode off
Machine 1
If no changes are made in "Multiple probe mode", then deflecting the
stylus for more than 4 seconds will return the probe settings to beginning
of the Trigger Logic menu. If "Multiple probe mode" is selected, proceed to
"Acquisition mode" to repartner one probe with the RMI-Q.
NOTE: If using "Multiple probe mode", refer
to the installation guide RMI radio machine
interface (Renishaw part no. H-4113-8554) or the
installation guide RMI-Q radio machine interface
(Renishaw part no. H-5687-8504).
NOTE: To partner an RMP400 with an RMI
please see "RMP400 – RMI partnership". Once
acquisition has been successful, the RMP400 will
Draft 5 16/04/18
revert to "Acquisition mode off".
Acquisition mode
Acquisition mode off
Hibernation mode (only for "radio on")
On On
30 s 5 s
Stop triggering here, unless "Multiple probe
mode" is required, in which case deflect the
stylus for more than 4 seconds.
Mode on
Machine 2
Acquisition mode
Acquisition mode off
Return to the beginning of the Trigger Logic menu
NOTE: Further probes used require the same
"Multiple probe mode" setting, but do not need
to be partnered with the RMI or RMI-Q.
NOTE: To partner an RMP400 with an RMI-Q
please see "RMP400 – RMI-Q partnership". Once
acquisition has been successful, the RMP400 will
revert to "Acquisition mode off".
Acquisition mode on
Off
Machine 16
Acquisition mode on
120 seconds
probe in standby
120 seconds
probe in standby
New settings
complete,
probe in
standby
4.7