LOGICDATA SILVERstandard Owner's Manual page 31

You can change the saved Memory Positions to new Memory Positions that you find more com-
fortable. To do this, proceed as follows:
1. Press and hold the UP or DOWN Button for the Platform you wish to adjust
2. Wait until the Bed Frame has reached the desired position
3. Release the UP or DOWN Button
4. Press and hold the Memory Position Button that you wish to save the new
position to for at least three seconds
5. Release the Memory Position Button
6.
MOVING THE BED FRAME TO A SAVED MEMORY POSITION
Proceed as follows to move the Bed Frame to a saved Memory Position:
1. Press the Memory Position Button for the Memory Position you wish to
move to (for less than three seconds)
2. Wait for the Bed Frame to move to the saved Memory Position
3.
MOVING THE BED FRAME TO THE SLEEPING POSITION
4.
The Sleeping Position is the Bed Frame's lowest position. While in the Sleeping Position, all Plat-
forms are horizontal. Proceed as follows to move the Bed Frame to the Sleeping Position:
1. Press the Sleeping Position Button (do not hold the Button)
2. Wait for the Bed Frame to move to the Sleeping Position
3.
PERFORMING A FLAT POSITION RESET
To perform a Flat Position Reset, press the Sleeping Position Button for at least 15 seconds, then:
1. The Remote Control displays "F" to confirm the input.
2. Press and hold the Sleeping Button again to move the bed to the flat position
3. The Reset is complete
If two beds are in Wireless Sync Mode, turn off Wireless Sync and reset each bed separately
ACTIVATING THE CHILD LOCK
Always activate the Child Lock when children are near the Bed Frame. Proceed as follows:
1. Press and hold Child Lock Button for at least three seconds
2. Ensure that the LED Array shows "L". This means the Child Lock is active
3. To de-activate the Child Lock, press and hold the Child Lock Button for at
least three seconds
SILVER SERIES OWNER'S MANUAL // 31