LOGICDATA SILVERstandard Owner's Manual page 23

2x
NOTICE
Ensure that the Power Converter Cable is connected to the white, 10-Pin Plug Port on the Side Rail.
Connecting the Power Cable to a different Plug Port may cause irreparable damage to the system.
CAUTION
Risk of minor or moderate injury through tripping
While mounting the Leg and Foot Platforms (N, O), you may have to step over the Side-to-Side
Cable (I) or the Power Cable (K). Tripping over a Cable may lead to injury.
• Be careful not to trip over the Cables
MOUNTING THE LEG AND FOOT PLATFORMS
H
N
O
To connect the USB modules:
1. Create a loose loop with
the USB Cable (H) and run
the Cable through the des-
ignated channel.
2. Plug the USB Cables into
the 2-Pin Plugports on ei-
ther side of the Bed Frame
1. Lay the Foot and Leg plat-
forms (N, O) across the
frame so that their holes
are aligned with the
holes on the side rails
(A, B).
2. Use the remaining 6
mounting screws (P) to
fix the Foot and Leg Plat-
forms (N, O) by hand.
Turn each screw until it
is hand-tight.
SILVER SERIES OWNER'S MANUAL // 23