Supermicro X11SSL-nF User Manual page 87

Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disabled and Enabled.
Port 0 ~ Port 5 SATA Device Type
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
*If the item above "SATA Mode Selection" is set to RAID, the following items will
display:
SATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI drvier for system boot. Select Legacy to load a legacy driver
for system boot. The options are Legacy ROM and UEFI Driver.
SATA Frozen
Use this feature to enable the HDD Security Frozen Mode. The options are Disabled and
Enabled.
Serial ATA Port 0~ Port 5
This feature displays the information detected on the installed SATA drive on a SATA port
specified by the user.
Port 0 ~ Port 5 Software Preserve
The status of software preserve of a SATA port will display as it is detected by the BIOS.
Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disabled and Enabled.
Port 0 ~ Port 5 SATA Device Type
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
PCIe/PCI/PnP Configuration
The following information will display:
PCI Bus Driver Version
PCI Devices Common Settings:
87
Chapter 4: BIOS