5.17 Configuring the Configuration tab - Channel block
Configuring modules - Identification tab
The following configuration information pertains to the Configuration tab for Series 8
I/O Analog Input or Analog Output modules.
Prerequisites
Control Builder is running
A Series 8 I/O control module was created
Considerations
All illustrations used in the procedure are for example purposes only.
The following is an example of an Analog Output Channel Block, Configuration form -
Configuration tab.
Note: When Enable Open Wire Detection (OWDENBL) check box is selected for
TC/RTD channel, the alarm is not generated.
R500
April 2017
5. Series 8 I/O Configuration Form Reference
5.17. Configuring the Configuration tab - Channel block
Series 8 I/O User's Guide
Honeywell
139