Average Setting Area (Address 14~17); Average Value - Honeywell TC4S User Manual

Average setting area (address 14~17); average value

1. If averaging process is sampling, the setting has no effect.
2. If any value other than the above value is set, the boundary values of each range are
set internally; %UXa.b.24 ~ 27 (setting error flag) is ON (the bit, 3 of setting error
information area (address 60 ~ 63) will be ON.), that is, if you select time average
and the average is set as 200, it operates as internal default. However, if parameter
window of SoftMaster is used, it prohibits the setting of a value that is out of range
value (if incorrectly set, it indicates the value in red and shows a message to re-set).
3. The averaging value assignment area is equivalent to the averaging value
assignment in I/O parameter setting window as shown in the following figure.
R200 Isolated Thermocouple Input Module TC4S User's Guide
September 2010
5.3. Operation parameter setting area
Honeywell
5. Internal Memory
79