5.15 Configuring The Calibration Tab - Iom Block; Configuring Modules - Calibration Tab - Honeywell Series 8 I/O User Manual

5. Series 8 I/O Configuration Form Reference
5.15. Configuring the Calibration tab - IOM block

5.15 Configuring the Calibration tab - IOM block

Configuring modules - Calibration tab

The following configuration information pertains to the Calibration tab for the following
modules:

ANALOG INPUT WITH HART

ANALOG INPUT

TC/RTD

Analog Output
Prerequisites

Control Builder is running

A Series 8 I/O control module was created
Considerations
Calibration can only be performed from the Monitoring side.
The Execution State must be set to IDLE before enabling calibration.

All illustrations used in this procedure are for illustration purposes only.
The following is an example of an ANALOG INPUT WITH HART Block,
Configuration form - Calibration tab.
134 Series 8 I/O User's Guide
Honeywell
R500
April 2017